Viper 500HF Installationsanleitung PDF herunterladen (Seite 11)

11 N438 7/98

Green (-) Multiplex input: Inputs shorter than .8 seconds will trigger the Warn Away

response, while inputs longer

than .8 seconds will trigger full alarm sequence and report zone four. If installing an optional DEI

dual stage sen-

sor, connect to the green wire as shown below. The diagram below eliminates the need for diodes to isolate the

sensors, as well as providing a seperate zone for each sensor.

Diagram for adding optional DEI

dual stage sensor to GREEN wire (zone 4)

Blue (-) Multiplex input: Inputs shorter than .8 seconds will trigger the Warn Away

response, while inputs longer

than .8 seconds will trigger full alarm sequence and report zone two.

Red, Black: Red is (+)12V constant, black is (-) ground. Do not use these for anything besides the plug in shock

sensor.

H1/11 RED

(+)12V constant power input: Before connecting this wire, remove the supplied fuse. Connect to the

battery positive terminal or the constant 12V supply to the ignition switch as described on Page 5.

NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A fuse in the

harness for this purpose. This fuse protects the module itself.

H1/12 RED/WHITE

channel 2, (-) output: When the system receives the code controlling channel, for longer than

1.5 seconds, the red/white will supply a (-) 200mA output as long as the transmission continues. This is often used

to operate a trunk/hatch release or other relay-driven function.

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transistorized

output can only supply 200 mA of current, connecting directly to a solenoid, motor, or other high-current

device will cause it to fail.

These plug into the module. The Status LED plugs into the small two-pin socket, while the Valet

/Program Switch

should be plugged into the larger blue two-pin connector. The Status LED fits in a 9/32" hole.

Status LED Valet

/Program Switch

FOUR-PIN SHOCK SENSOR HARNESS

LED AND VALET

/ PROGRAM SWITCH

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Keine Kommentare

Viper 500HF Installationsanleitung Seite 11