Viper 5601 Installationsanleitung PDF herunterladen (Seite 9)

¢ Status LED

The status LED is built into the control center. An optional LED (p/n 8634)

is available if the onboard LED is not used for the install. The LED ﬁts into a

9/32-inch hole.

¢ Doubleguard shock sensor

Since the shock sensor is built into the main unit, be sure to keep the shock sensor

performance in mind when deciding on a location for the main unit.

Note:

In many vehicles, fastening the main unit (the brain) to a steering column

or screwing it to metal will result in poor sensitivity, especially at the rear of the

vehicle.

¢Before beginning the installation

Please read this entire installation guide before beginning the installation. s

The installation of this remote start system requires interfacing with many of

the vehicle’s systems. Many new vehicles use low-voltage or multiplexed

systems that can be damaged by low resistance testing devices, such as

test lights and logic probes (computer safe test lights). Test all circuits with a

high quality digital multi-meter before making connections.

Do not disconnect the battery if the vehicle has an anti-theft-coded radio. s

If equipped with an air bag, avoid disconnecting the battery if possible.

Many airbag systems display a diagnostic code through their warning

lights after they lose power. Disconnecting the battery requires this code to

be erased, which can require a trip to the dealer.

If using an external LED or Valet Switch, check with the customer about s

where to locate the switch.

To avoid accidental battery drainage; turn off the interior lights or remove s

the dome light fuse.

Roll down a window to avoid being locked out of the car.s

¢After the installation

Test all functions. The “Using Your System” section of the Owner’s Guide is s

very helpful when testing.

When testing, don’t forget that this system is equipped with Nuisance s

Prevention® Circuitry (NPC). NPC can bypass trigger zones, making them

appear to stop working. See the Nuisance Prevention® Circuitry section

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

Keine Kommentare

Viper 5601 Installationsanleitung Seite 9