Viper 5806V Bedienerhandbuch PDF herunterladen (Seite 29)

Trigger Zone Fault Report

When armed by remote command the system runs a status check

of the alarm trigger zones. Faulty zones (usually caused by dome

light delay or open trunk) are bypassed and reported via the control

center LED and remote, while all other trigger zones remain active

and are monitored to protect the vehicle. Should a faulty zone self

correct (dome light turns off) it becomes active and is then monitored

normally.

The siren chirps once again a few seconds following the arming

chirps as an audible alert, the control center LED ﬂashes in groups to

indicate the zone number.

Alarm Report

If the alarm was triggered while armed, it will be reported when

the alarm is disarmed via the remote control, siren chirps, parking

light and control center LED ﬂashes. The siren chirps four times (or ﬁve

times if NPC On*), the parking lights ﬂash three times, and the control

center LED ﬂashes in groups to indicate the last two zones that were

triggered (see Table of Zones). The report output will repeat for each

disarm operation until the ignition is turned on.

Table of Zones

Zone # (led flashes) Zone Name

1 Trunk

2 Shock Sensor

3 Door

4 Sensor 2

5 Ignition

6 Hood

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 52 53

Keine Kommentare

Viper 5806V Bedienerhandbuch Seite 29