Rev.: 20130222
Platform: DBALL
Firmware: TL2 Remote Start Ready Installation (RSR)
© 2012 Directed. All rights reserved.
Page 16
LED Diagnostics and Troubleshooting
Flashes Diagnostic
1 Runtime expired.
2 Over-rev shutdown.
3 Low/No RPM.
4 Transmitter shutdown.
5 Brake shutdown.
6 Hood shutdown/Remote start safety override switch is ON*.
7 Remote start safety override switch is ON*.
The parking lights on your vehicle will flash a specific number of times 3 seconds following an unscheduled shutdown or
failure to start. Each flashing pattern is described below.
* If the vehicle hood status is supported through data, safety override switch input will report 7 flashes.
Parking Light Error Codes
LED Status Description Troubleshooting
Programming the Module
Solid Red
Waiting for the completion of a
programming sequence, or for
the ignition to be turned ON.
This can also mean that there is an issue with the
data bus wiring. Make sure that the connections to the
data bus are correct by referring to the wiring diagram.
Flashes Red 5x BRX signal not detected.
The BRX wire may be incorrectly connected. Refer to
the wiring diagram to make the right connections.
Flashes Red 6x BTX signal not detected.
The BTX wire may be incorrectly connected. Refer to
the wiring diagram to make the right connections.
Solid Green x3
seconds
Module successfully
programmed.
Normal operation
Solid Orange x3
seconds
Module successfully
programmed without bypass.
OEM remote starter has been detected, you can either
keep the OEM remote starter mode or disconnect it.
See page 3 for more information.
Off Module has no power.
Make sure that the D2D harness is connected or that
the 12 Volt is present between the red and black
wires. If the 12 Volt is present, the module may be
defective.
Remote Starting the Vehicle
Flashes Green Module is operating correctly. Normal operation
Flashes Red 10x Vehicle not ready to start.
Make sure that all doors, hood, and trunk are closed.
Cycle ignition ON and OFF.
Flashes Red 5x Bypass failed.
A problem with the bypass was detected. Check your
connections to the CAN, BRX, and BTX and try to
reprogram the module if the problem persists.
Flashes Red 7x Module not in RSR mode
Remote start the vehicle in RSR was attempted
without activating the RF_OUTPUT. See page 12 for
more information. RFTD feature has not been
activated.
Off Normal operation
The Ground While Running (status) wire is incorrectly
connected. Refer to the wiring diagram to make the
right connections.
While the Ignition is Turned Off
Flashes Green 1x Lock feature executed.
Flashes Green 2x Unlock feature executed.
Flashes Green 3x Trunk release feature executed.
Flashes Green 4x
AUX1 (Right Sliding Door) or
AUX2 (Left Sliding Door) feature
executed.
If it does not flash, the bypass module did not receive
the signal. Verify the connections between the bypass
and the remote starter module.
Solid
Flashes
5x
Flashes
6x
Flashes
Flashes
7x
Flashes
5x
Flashes
10x
Flashes
1x
Flashes
2x
Flashes
3x
Flashes
4x
Solid
x3 secs
Solid
x3 secs
Off
Off
(30 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern