Viper 2.08 Spezifikationen PDF herunterladen (Seite 231)

221

Manual # 016-0159-894 Rev H 01/07

7 - Using AutoBoom

Autoboom uses default settings for sensor height, sensitivity and speed.

Normally, these values will work for your machine. The default setting for

the Sensitivity is 15 and the Speed is 25. If the booms start to oscillate or

act otherwise unstable, this is an indication that either the Speed or the

Sensitivity is set too high. Reducing the set point for either should improve

performance. Once the Speed and Sensitivity are set, only minor adjust-

ments are required to account for changing field conditions. The height of

the boom above the ground can also be adjusted by setting the height of

the ultrasonic sensor over the ground.

To adjust the Speed, Sensitivity, and/or Sensor Height settings of Autoboom,

press in the center portion of the Autoboom area on the Viper main menu

screen. The following screen will display.

To Adjust Sensor Height:

1. Press the up arrow in the Sensor Height area of the Autoboom

Control screen to increase the distance of the ultrasonic sensor

and the ground.

2. Press the down arrow in the Sensor Height area of the Autoboom

Control screen to decrease the distance of the ultrasonic sensor

and the ground.

To Adjust Sensitivity:

1. Press the up arrow in the Sensitivity area of the Autoboom

Control screen to increase the sensitivity of the boom response.

2. Press the down arrow in the Sensitivity area of the Autoboom

Control screen to decrease the sensitivity of the boom response.

UltraGlide

System

Adjustment

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 341 342

Keine Kommentare

Viper 2.08 Spezifikationen Seite 231