Viper 3606V Installationsanleitung PDF herunterladen (Seite 7)

Pairing a Remote Control

Prepare the system

Open1. a door.

Turn2. the ignition on.

Press3. and release then press and hold the control center button. The control center LED ﬂashes and the

siren chirps one time to conﬁrm the system is prepared.

Release4. the button and proceed below.

Note:

Begin Pairing within 60 seconds or the system will exit (indicated by a long siren chirp) and need to

be prepared again.

Prepare the LC remote control

Select the desired car 1 (default) or car 2 operation before proceeding.

Press1. and hold the

A U X

button of the remote control until a long beep is emitted and

Main Menu

is dis-

played (if programmed to operate two systems, ignore the car 1 or car 2 text and beeps at 3 seconds).

Release2. the

A U X

button to view the main menu.

Remote Setup

is displayed

Press3. and release the

A U X

button two times.

Pair Remote

is displayed.

Press4. and hold the

A U X

button until

Pair

is displayed, and then release it.

Press5. and hold the

A U X

button until the siren emits a long chirp.

Success

is displayed with a sequence of

chimes.

Note:6. If

Failed

is displayed, make sure the system is still prepared and repeat step 5 until successful.

Prepare the system to be paired with the companion 1-way remote as described above.

Note: If no remote pairing results, the system will exit after 60 seconds.

Prepare the companion 1-way remote control to be paired with the system:

Select the desired car 1 (default) or car 2 operation before proceeding.

Press and hold the 1.

A U X

button for 8 seconds until the transmit LED turns on, and then release it (If pro-

grammed to operate two systems, ignore the transmit LED ﬂashes at 3 seconds).

Press and hold the 2.

A U X

button until the transmit LED ﬂashes off and on three times.

Press and hold the 3.

A U X

button until the siren emits one long chirp to conﬁrm Pairing.

To exit Pairing mode:

Turn off the ignition, the siren will emit one long chirp. 1.

Press and hold the 2.

A U X

button on the remote and then press and hold to return the remote control to normal

operation (transmit LED turns off).

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Viper 3606V Installationsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Viper 3606V