Viper 320HV Installationsanleitung PDF herunterladen (Seite 6)

This wire is used in vehicles that have a positive (+) switched domelight circuit. Connect the violet wire to a

wire that shows (+)12V when any door is opened, and ground when the door is closed. This wire will report Zone 3.

Remove any paint and connect this wire to bare metal, preferably with a factory bolt rather than a screw. (Screws

tend to strip or loosen with time.) We recommend grounding all components, including the siren, to the same point.

Connect this wire to an ignition source. This input must show (+)12V with the key in run position and during

cranking. Make sure that this wire cannot be shorted to the chassis at any point. This wire will report Zone 5.

Connect this to the red wire of the siren. Connect the black wire of the siren to (-) chassis ground, preferably at

the same point you connect the control module’s black ground wire.

HH11//1100 BBRROOWWNN ((++)) ssiirreenn oouuttppuutt

HH11//99 YYEELLLLOOWW ((++)) iiggnniittiioonn iinnppuutt,, zzoonnee 55

HH11//88 BBLLAACCKK ((--)) cchhaassssiiss ggrroouunndd ccoonnnneeccttiioonn

HH11//77 VVIIOOLLEETT ((++)) ddoooorr ttrriiggggeerr iinnppuutt,, zzoonnee 33

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

Keine Kommentare

Viper 320HV Installationsanleitung Seite 6